TECH HELP
Will AUS 1200cc side feed injectors idle and run well on pump gas?
We have had a couple people say that they and or their tuner could not get their Z32's to run well or idle on pump gas. We have wondered if this was an issue with the injectors or the tuning. Up until recently, we have only ever tuned Z32's with these injectors that were running E85 full time, not on a flex fuel car that can run on gasoline. We have not had any issues with these injectors on E85. We recently had an opportunity to tune a customers Z that has these injectors running on a Haltech Elite 2500 with a flex fuel sensor. This is a video we made to show this car idling very well on gasoline. We hope this serves to show that these injector will run fine when tuned by someone that knows how to so. If you need your Z tuned with these injectors, please reach out to us to set up a dyno tuning date.
INTRODUCING OUR NEW AND IMPROVED AUS INJECTORS.
Introducing the new AUS injector design. We contacted AUS with an idea to improve the general design of the side feed injectors and the good peopl...
ZSHACK L.E.D.BULB KIT INSTRUCTIONS FOR MANUAL A/C CONTROLS
ZShack L.E.D.interior light installation instructions for manual A/C pod
The following is a list of the bulb sizes and where they go.
194— is for...
ZSHACK L.E.D. BULB KIT INSTRUCTIONS FOR AUTOMATIC CLIMATE CONTROL
ZShack L.E.D.interior light installation instructions for Auto A/C pod
The following is a list of the bulb sizes and where they go.
194— is for t...
In Depth Guide To Turboing Your NA Compression vg30de Motor (300zx):
In Depth Guide To Turboing Your NA Compression vg30de Motor (300zx):
In this guide I'll be talking about these key points:
-Engine health, and te...
ARP2000 Head studs, The truth about them
ARP 2000 Head Stud information
Do you have ARP2000 head studs in your VG engine? You may think you do but you likely do not if you bought them...
GM LS2 (D585) COIL PACK SWAP
GM LS2 (D585) COIL PACK SWAP
Many of you have been asking how I did my GM Ls2 coil pack swap, so here is my write up on how to do it step by s...